If your Linksys Velop mesh system is connected to an existing upstream network you must configure it in Bridge Mode. Your Velop nodes will behave as though they are a single network in this mode facilitating smooth device-to-device communication. Here is a thorough how-to for setting up Bridge Mode on your Linksys Velop:
Bridge Mode: What Is It?
When you wish to integrate your Velop mesh system into the network and already have a router (modem gateway) you can utilize bridge mode. Your Velop nodes will function in harmony with your current network when in Bridge Mode providing a cohesive experience.
Requirements to linksys velop bridge mode setup
Make sure the following prerequisites are satisfied before linksys velop bridge mode setup to operate it:
- Linksys Smart WiFi Router: A Linksys Velop router is required.
- Ethernet Wires: Make sure you have two Ethernet wires on hand.
- A live internet connection: it should be established using your current modem or modem-router.
How to linksys velop bridge mode setup:
Basically there are two ways to configure brige mode on linksys velop
linksys velop bridge mode setup using the app
Set up the Velop Nodes:
- If your current router has Wi-Fi enabled, turn it off to avoid IP address conflicts.
- Using an Ethernet cable attach one of the Velop nodes—typically the main node—to a LAN port on your router.
- After plugging in the main Velop node watch for it to start up.
Transfer the Linksys app:
- Unveil the Linksys app on your phone and log in.
- After tapping the menu icon choose “Advanced Settings.”
- Select “Internet Settings.”
- Choose a Bridge Mode.
- Click on Connection Type and select Bridge Mode.
- Click “Save.”
- Tap “Enable Bridge Mode” to confirm.
Crucial Information:
- Bridge Mode may cause your devices to momentarily disconnect while the adjustments take effect.
- The parent node (primary Velop) needs to be kept wired up with an Ethernet connection to your current modem router.
- Child nodes have Ethernet and Wi-Fi connectivity options.
Check the IP address.
- Use the Linksys app to find your router’s new IP address under the Network Administration area.
- Be aware that when in Bridge Mode certain functions (including Safe Browsing and Parental Controls) are not available.
Returning to Normal setting:
- Launch the Linksys app, navigate to Advanced Settings > Internet Settings and choose “Disable Bridge Mode” to return to the previous setting or turn off Bridge Mode.
Using Web interface for linksys velop bridge mode setup
Use the web interface to set up Bridge Mode on your Linksys Velop mesh system by doing the following steps:
Open the Linksys Velop and log in:
- You can access the Linksys Velop web interface by using your login credentials.
- Press and hold the Menu icon then choose Advanced Settings.
Select the Internet Settings:
- Find and select Internet Settings from the advanced settings.
- Choose a Bridge Mode on linksys velop setup.
- Seek out the option labeled Connection Type.
- That’s where the Bridge Mode setting is located.
- After selecting it press Save.
Why does linksys velop bridge mode setup not working and how to fix
In case you’re facing difficulties with Linksys Velop’s Bridge Mode the following typical issues and their fixes are listed:
No connection to the Velop network:
- Try reconnecting after resetting the Velop system.
Slow Wi-Fi speeds:
- Adjust the Velop nodes or look for other electronic devices causing interference.
Unable to Enable Bridge Mode:
- Check to See if bridge mode is supported by your current router. This feature might not work with some routers.
Final thoughts
Recall that Bridge Mode makes it easier to integrate with your current network and guarantees smooth communication between all of your devices. If you need any help further for linksys velop bridge mode setup please visit our webpage.
